can this router handle it and put out that fibre speed

Question

I have upgraded to fiber @ 300gb/s. Can this router put that much out? I have sen netgear 5 and 6 , my box and info does not tell me anything&nbsp;

FURRYe38 · Answer

What router model do you have? R####, RAX####? Orbi RBK?&nbsp;
&nbsp;
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

Rhinorider · Answer

FURRYe38&nbsp;wrote:What router model do you have? R####, RAX####? Orbi RBK?&nbsp;&nbsp;What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?I have an R7200 The isp&nbsp; It is conected to is an Action net do not know the model. Its a piece of crap

Rhinorider · Answer

&nbsp;FURRYe38&nbsp;wrote:What router model do you have? R####, RAX####? Orbi RBK?&nbsp;&nbsp;What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?The model is an Actiontec 1565 2.4g mine is NG R7200

microchip8 · Answer

300 gb/s??? Do you mean 300 Mbps? if so, this router model shouldn't have problems to reach it

FURRYe38 · Answer

FYI about modems with built in routers and wifif,&nbsp;This would be a double NAT condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAThttps://kb.netgear.com/30187/How-to-fix-issues-with-Double-NATCouple of options,1. Configure the modem for transparent bridge or modem only mode. Then use the NG router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the NG router gets from the modem. https://kb.netgear.com/25891/DMZ-on-NETGEAR-routershttps://kb.netgear.com/24086/How-do-I-set-up-a-default-DMZ-server-on-my-Nighthawk-router3. Or disable all wifi radios on the modem and connect the NG router to the modem, LAN to LAN configure AP mode on the NG router. https://kb.netgear.com/24104/How-do-I-change-my-Nighthawk-router-to-AP-mode-after-I-ve-already-run-setup
Rhinorider&nbsp;wrote:
&nbsp;
FURRYe38&nbsp;wrote:
What router model do you have? R####, RAX####? Orbi RBK?&nbsp;
&nbsp;
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

The model is an Actiontec 1565 2.4g mine is NG R7200

&nbsp;

Forum Discussion

can this router handle it and put out that fibre speed

5 Replies