NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
How to enter in Failsafe mode on a Nighthawk?
Hello!
What are the steps to enter in failsafe mode on the nighthawks?
Trying to recover a bricked R7800
What are the steps to enter in failsafe mode on the nighthawks?
Trying to recover a bricked R7800
4 Replies
you can try using tftp or nmrpflash.
are you on windows? if so, follow this guide
https://kb.netgear.com/000059634/How-to-upload-firmware-to-a-NETGEAR-router-using-Windows-TFTP
just make sure you enable tftp
https://www.thewindowsclub.com/enable-tftp-windows-10
and here's a video walk through.
https://www.youtube.com/watch?v=R9DLrLQrpaw
and if that doesn't work, you can try using nmrpflash
- I did ask for failsafe mode because the router before it was in bootloop, and now is blinking in orange each sec the power led, so I am trying to figure what mode I am entering in the router, which I don't have a clue.
Not sure exactly what you think "failsafe" mode is.
did you try the tftp or nmrpflash? They're designed to reinstall a firmware in case of bricked devices, corrupt firmware, etc.
Failsafe *usually* implies backup firmware on a device that it can revert to. Netgear consumer routers don't have this.
voloff wrote:
What are the steps to enter in failsafe mode on the nighthawks?Like plemans I have no idea what you mean by that.
It isn't a term I have seen in some years hanging around here.
As plemans says, the usual escape route is TFTP. Any reason why you rejected that advice?
There is more severe, recovery reset, that you could try:
- Press reset for 30 seconds
- Keep pressing reset while removing power
- Keep pressing reset for another 30 seconds while apply power
If it works, you may be able to use the usual method to flash the firmware again.
Download the latest firmware for your device – or an older version if that is what you want – and read the Release Notes for how to install it.
If that fails, you are into TFTP country.
How to upload firmware to a NETGEAR router using Windows TFTP | Answer | NETGEAR Support
