R7800, /23 LAN mask. Config advice to get DHCP pool & GW at either ends of the subnet. Voxel f/w.

Question

Hi, I have an R7800. I've configured a /23 mask for the LAN. I would like my router ip/gateway to be in the bottom half of the subnet and the DHCP pool to be in the uppper half. In the GUI I can only put the router IP and DHCP pool in the same /24 subnet. Can I edit the DHCP config from the CLI, and if so, what commands do I need to use. I've tried looking for a command line reference but I can't find anything for the R7800.

I'm running a Voxel firmware, R7800-V1.0.2.97SF.

Thanks.

plemans · Answer

If you're running 3rd party firmware (voxels), you'll need to ask on that specific forum and not on the stock firmware forum.&nbsp;

Kitsap · Answer

In case you have not already discovered it:&nbsp;https://www.snbforums.com/forums/netgear-ac-wireless.53/&nbsp;&nbsp;&nbsp;

nickat1 · Answer

Thanks. I'll repost.&nbsp;

nickat1 · Answer

Thanks, I'll check it out.&nbsp;

Forum Discussion

R7800, /23 LAN mask. Config advice to get DHCP pool & GW at either ends of the subnet. Voxel f/w.

4 Replies