NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

JSyverson's avatar
JSyverson
Follower
Dec 30, 2025

BE17000 as a bridge

Hello:

 

I am trying to use the BE17000 as a bridge.  I want to take in tri-band wireless signals from another BE router and break them back out to cables.  Does anyone have an idea on how to do this.  I have tried and failed.  Everything I find even on here talks about pages my firmware (V1.0.5.22) does not have.  The only page that I have talking about a bridge is ADVANCED>Advanced Setup>VLAN/Bridge Settings.  I have the Bridge group defined but I can't figure out what to do next.  

 

Any help anyone could offer would be greatly appreciated.  

 

Thanks in advance

 

JSyverson

rs600

3 Replies

  • coolwifi's avatar
    coolwifi
    Luminary
    Dec 30, 2025

    Netgear removed the bridge feature from its routers long time back.

    • FURRYe38's avatar
      FURRYe38
      Guru - Experienced User
      Dec 30, 2025

      Bridge mode has been around up to the RAX and RAXE series, However is not supported on the RS series. I asked about it.