NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

fbeinfo's avatar
fbeinfo
Guide
Nov 25, 2024

no WWW access after 24 hours and only on one client in the NETWORK - NETGEAR RS200

Hi all

Here my Router data first

Hardware VersionRS200
 
Firmware VersionV1.0.1.60
 
GUI Language VersionV1.0.0.449
 
Protection Engine Version2.2.214.4/1.0.0.2061
Operation ModeRouter
 
CPU LoadCPU1: 17.20% CPU2: 17.85% CPU3: 17.17% CPU4: 16.87% 
 
Memory Usage (Used/Total)607MB/2018MB
 
Flash Usage (Used/Total)429MB/512MB

 

 

I've in my home Network about 30 connected devices.

DHCP is from 192.168.1.100-255 in the range below some fix ip's are assigned.

PROTECTION ENGINE IS TURNED OFF

it's only on one client where after 24 hours - or even sometimes after a reboot i get only access to the intranet but no WWW anymore

When the protection engine is on - i encounter this after 2 hours.

the client - my desktop PC - gets either auth. problems or cannot connect to the WWW anymore. Respectively it can only reach the IP's in the Home Network.

What i have to do then is to assign another IP in the IPV4 normally the internet connection runs then normal again.Also a fushdns or an ipconfig /renew doesn't help

Windows 11 told me that there is a problem with the DNS cache.....

After a manual change of the IP i can use the PC for the next day till i've to change again.

Also the activation of DHCP delivered very similar problems. (i've to deactivate the connection, then reactivate, ipconfig /renew)  etc.....

 

Is there a firmware update?

 

 

 

 

 

 

1 Reply

  • FURRYe38's avatar
    FURRYe38
    Guru
    Nov 25, 2024

    If it's only the one PC, and nothing else sees this issue, you'll need to take a closer look at the PC. 

    Check wired vs wireless connections. 

    Be sure all ethernet and wireless adapter drivers are updated from there Mfr. 

    Contact the PCs mfr for help and support information regarding there product.