NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RS700 IPv4 Lease Not Renewing (still not fixed).
I have a Nighthawk RS700 currently running firmware 1.0.9.16. There is a problem with renewing the IPv4 lease. If I restart the router it picks up an Ipv4 address with a 24 hour lease. After 12 ho...
Does the ISP required any special WAN connect configurations like PPPoE or is the connection all DHCP?
What CAT# LAN cable is in between the ONT and RS router? CAT6A STP is recommended.
Is Protection Engine enabled on the RS router?
Is IPv6 enabled on the RS router?
Have you tried a Non managed LAN switch in between the ONT and RS router? Seen it where some handshaking between a ONT and router can be resolved with a lan switch in the middle.
Thanks for very much your response. My answers in italics
Does the ISP require any special WAN connect configurations like PPPoE or is the connection all DHCP?
No, no special connection just plain old DHCP and both my RS200 and AX6000 work fine.
What CAT# LAN cable is in between the ONT and RS router? CAT6A STP is recommended.
Cat8
Is Protection Engine enabled on the RS router?
Yes
Is IPv6 enabled on the RS router?
Yes, and it works fine. It continues to work even when IPv4 drops.
Have you tried a Non managed LAN switch in between the ONT and RS router? Seen it where some handshaking between a ONT and router can be resolved with a lan switch in the middle.
Unlikely, to be the problem as this only started with firmware update 1.0.9.6 and can fixed by downgrading to version 1.0.7.96 but, I'll give it a try.
Is the CAT8 UTP or STP? STP is preferred.
Please disable Protection Engine on the RS router.
Is the CAT8 UTP or STP? STP is preferred.
I honestly couldn't say as it is covered with fabric, so you can't read what may be printed on it. However, I have now connected the router to the ONT with the cable that came in the box with the router, which I believe to be the original cable. It does have CAT6 printed on it.
Please disable Protection Engine on the RS router.
My apologies, I was connected to my RS200 when I said that the protection engine was enabled. Looking at the RS700 there is nothing labelled Protection Engine. There is Online Armour, but that has never been activated.
Many thanks for your help with this. It is much appreciated