NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
My Ready NAS Duo will not go into the reset mode.
I have followed the instructions and the NAS RND2110-100NAS will not go into the Boot menu. All I get is the power button light flashing. Do I have a bad board, or it it operator error? I have tried...
Hi WesleyB,
Welcome to the community!
Did you try this procedure with hard drive/s installed? If yes, how many? I also suggest that you put healthy or fresh hard drive/s that is listed in our HCL.
Kind regards,
BrianL
NETGEAR Community Team
I'm having a similar issue. I had to run a reset since the unit is non-responsive. I've tried reseating the memory.
Now after trying to reset I get the disk 1 LED flashing twice slowly, then the power, ACT and disk 1 LED all flashing together three times quickly. Then repeat.
I've tried resettting but no go.
Any ideas?
Hi Starlionblue3,
Can you check if you're using a V1 or V2 unit? Kindly check this page for more information.
Kind regards,
BrianL
NETGEAR Community Team
BrianL2 wrote:Hi Starlionblue3,
Can you check if you're using a V1 or V2 unit? Kindly check this page for more information.
Kind regards,
BrianL
NETGEAR Community TeamThe bottom says RND2000 v2 but the back looks like a V1. It has the smaller fan.
Update: I reseated the memory for the nth time and now it takes the reset, as in I don't get the triple flash. It did the first flash after 5 and second flash after 25. However now it has been sitting for hours with pulsing blue. Is this the disk check?
Hi Starlionblue3,
Thank for providing the info that I asked for. Could you run the RAIDar utility to see what the device does? If this sits for more than 30mins or an hour, I suggest that you try another hard disk (a fresh one) and do the same reset procedure.
Kind regards,
BrianL
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
