NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Network Access
I was able to access my RN314 ReadyNAS via any network computer but now get a message in Windows 11 "Path not found" how do I fix this?
Did you just update Windows 11 to 24H2?
saudade wrote:
Did you just update Windows 11 to 24H2?
That shouldn't create any issues with an RN314
My own PC is fine, I can access the shared folders and connect to the NAS through the UI.
But other PC's on the network can not, what I did this morning was go to start/run and type in the NAS IP address \\192.168.1.6 then enter and the hard drives starts spinning up and I get this error message
claynz wrote:
My own PC is fine, I can access the shared folders and connect to the NAS through the UI.
But other PC's on the network can not, what I did this morning was go to start/run and type in the NAS IP address \\192.168.1.6 then enter and the hard drives starts spinning up and I get this error message
Go into the Windows Credential Manager and see if there is a NAS username/password for 192.168.1.6. If there isn't, then add it.
Also, go into the SMB settings on the NAS, and make sure that "SMB 3 Transport Encryption" is set to "Enabled". ("Required" will also work, but some older devices might fail if you use "Required").
Depending your NAS setup, that setting might be in system->settings->services->SMB. Or it might be on the Advanced SMB settings for each share.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
