NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RN102 Firmware 6.10.7 problem
Hello everyone, I recently bought a second hand RN102 Readynas which was bricked when i bought it but it was £25 with 2 x 1TB disks so too good to turn down. I realise this is an old NAS and rea...
Goldie1980 wrote:
The only thing i can do is turn off at the wall and then using the boot USB drive inserted press and hold the backup button again, switch on at mains and then it reinstall the OS again and boots back up no problem and i can still access all my data.
This is repeating the USB recovery process. You are saying that turning on the switch at mains doesn't boot unless you also repeat the USB recovery?
Also does restarting the NAS from the admin web ui (NOT powering off) work? Or not?
Thank you for the reply StephenB
That is correct. Any power down either through the graceful shutdown or the power off at mains i have to redo the USB recovery process. If i leave the NAS powered on it is fine.
I tried the close down using the admin UI and then tried to start up from there too and the same result and it is very odd. I assume there is a small amount of internal memory the OS is saved to which is uses to boot from and this isn't working as intended (this probably shows my lack of actual knowledge).
Thank you for your help.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
