NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
All data usage showing up as snapshots
I'll preface this with the fact that I have no idea when this phenomenon showed up because I had not looked at my admin page in quite awhile. I use my NAS 104 primarily for DVD storage for my HTP...
A one-off snapshot upgrade didn't take place on your system.
I have sent you a PM.
If the balance doesn't resolve it send me your logs (see the Sending Logs link in my sig).
Balance freed up a little space, but the data / snapshot mix didn't change. Still show 26.8GB data and 5.05 TB of snapshots. Shot you over the logs. Thanks!
A one-off snapshot upgrade didn't take place on your system.
I have sent you a PM.Looks like your system has dropped off Secure Diagnostic Mode. It was in the middle of upgrading your snapshots.
If you can connect to the system please disable/re-enable Secure Diagnostic.
If you can't reboot the NAS and re-enable Secure Diagnostic Mode and let me know when done.Yes - looks like my broadband went down for a minute ... I lost all connectivity. I'm back up and dasabled and re-enabled. Same code.
Thanks!
The quotas are being recalculated. This may take quite some time.
You should gradually see that the amount shown in the UI as consumed by current data increases till it reaches the correct value.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
