NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
boot problem RN102 after update
Hi
I was working on my NAS, and I gues I triggered an update.
After the update I wasn't able to connect to my NAS.
What I did now is that I booted without disks, configured new NAS and then insterded my 2 disks again.
I activated the diagnostic mode under settings -> support -> diagnostic.
Can you please provide support.
Thanks.
Ben
4 Replies
Replies have been turned off for this discussion
A RedyNAS can't be configured that way. Strictly stick the documented installation procedure. The NAS configuration is held on the installed internal mass storage, no other config storage option.
... ac1200 wi-fi adapter usb 2.o a6150-100pas impossible to connect to router cambium networks ...
Similar, ReadyNAS does not support wireless clients like this named ac1200 wi-fi adapter usb 2.o a6150.
- This is what I get. I cannot afford to lose the data by deleting partitions on disks. Is there a way to recover data. I tried updating to latest firmware but it isnt booting drom disks. Only if i remove them i can boot.
- Oops. Image didnt upload. Its says “no volume exists” after plugging in my two RAID 1 disks
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
