NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
ERR Partitioning failed! Corrupt Root iln RAIDar
I just installed six HGST NAS 10TB drives in this unit and have ERR: Partitioning failed! and in RAIDar I have Corrupt Root. I ran Test Disks which went to 100 percent and then did a factory reset wi...
It looks like one of your disks might be bad: disk 1 or 2. I can only see 4 disks.
The firmware on the flash was fine, however I updated the firmware on the flash to 6.9.3 and got your NAS into the state it would've been in if it shipped from the factory today. I still only could see 4 disks.
You could have a bad disk or there could be a problem due to how disks were partitioned in a PC or perhaps even a problem with the firmware on the internal flash.
I've sent you a PM.
The unit may have shipped with 6.7.1 but if you updated the firmware since then the NAS would use the firmware you updated to when doing a factory reset.
It looks like one of your disks might be bad: disk 1 or 2. I can only see 4 disks.
The firmware on the flash was fine, however I updated the firmware on the flash to 6.9.3 and got your NAS into the state it would've been in if it shipped from the factory today. I still only could see 4 disks.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
