NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Firmware corrupted Root, can't access Admin page
Can anyone share some insight into the follow issue, the NAS Server discoverable and on the the network but can't access the Admin page. In the Netgear discovery tool I can see the device and sta...
ENROC wrote:
Tried Factory resetting and loading the firmware using the USB option
FYI, this was almost certainly more than needed. The system normally boots from a small OS partition on the drives. That file system can sometimes get corrupted. A USB recovery isn't normally needed (and has some risk). The usual recovery is to start with an OS reinstall, and if that fails, then try a factory default.
ENROC wrote:
note the device is on the IP 192.168.168.168 and can't even change back to 192.168.0.114 as it was previously before the reset.
The NAS will ask your router for an IP address (using DHCP). In your case, the NAS isn't getting an IP address, and it eventually fails over to 192.168.168.168. First try removing the network cable from the NAS, and connecting it again.
If that fails, you can try powering down the NAS, rebooting the router (and any intermediate switches), and then power up the NAS again, and see if that clears it.
It is also possible to do a direct connect procedure, and manually reset the IP to a 192.168.0.x address. But try those steps first.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
