NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Gbit Ethernet Flow Control on RN104
Hello Community, I have a question to my ReadyNAS RN104 running at FW level 6.10.4. When I look into the network interface settings, there's no information about flow control for Gbit Ethernet adap...
HolgerGT86 wrote:
I cannot figure out if flow control is enabled or disabled.
Is there a way to find this out?
You have to use ssh (ethtool). I see this on my RN102:
root@RN102:~# ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Advertised pause frame use: No Advertised auto-negotiation: Yes Link partner advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Link partner advertised pause frame use: Symmetric Link partner advertised auto-negotiation: Yes Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 0 Transceiver: external Auto-negotiation: on Supports Wake-on: g Wake-on: d Link detected: yesThis says that pause frames (ethernet flow control) are not supported. FWIW, it is supported (and enabled) on my x86 ReadyNAS.
HolgerGT86 wrote:
I cannot figure out if flow control is enabled or disabled.
Is there a way to find this out?
You have to use ssh (ethtool). I see this on my RN102:
root@RN102:~# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Link partner advertised pause frame use: Symmetric
Link partner advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: external
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Link detected: yes
This says that pause frames (ethernet flow control) are not supported. FWIW, it is supported (and enabled) on my x86 ReadyNAS.
Hi StephenB,
many thanks for your reply and sorry for my delayed response. My RN104 set the RAID5 volume to read only resulting from a filesystem failure and I had to start over and restore from backup. I was tied up by doing the recovery. All good now.
Have a great day,
Holger
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
