Forum Discussion

Aspirant

Jun 24, 2018

Solved

Ready NAS Duo v2 - dont see model and firmware in RAIDair

Hello, I have huge problem with my ReadyNAS Duo v2. Everytime when i turn it on everything looks fine, but when i try to find it in my network by using RAIDar it is visable without and model and fi...

Booting

Installation & Upgrade

mdgm-ntgr
Jun 24, 2018
That screenshot shows “No Disks Detected”. If the disks are fine that suggests a hardware issue with the chassis, not a problem on the internal flash.

It’s normal for it to not show the model when in the “No Disks Detected” error state.

mdgm-ntgr

NETGEAR Employee Retired

Jun 24, 2018

That screenshot shows “No Disks Detected”. If the disks are fine that suggests a hardware issue with the chassis, not a problem on the internal flash.

It’s normal for it to not show the model when in the “No Disks Detected” error state.

Madaxus
Aspirant
Jun 25, 2018
Hello mdgm,

Thank you for your answer. I was almost 100% sure it does not depends on disks hmm... I will try with two new disks today evening and check it again.
- Madaxus
  Aspirant
  Jun 26, 2018
  That was exacly HDDs. I was sure that the system files arent located on HDDs. I guess its solved, with new hdds everything works fine :)
  
  Thanks again for your support.
  - StephenB
    Guru - Experienced User
    Jun 27, 2018
    Madaxus wrote:
    
    I was sure that the system files arent located on HDDs.
    
    The operating system, ReadyNAS application software, and configuration settings are all stored on the HDDs. These are in their own (small) partitions which are mirrored on all disks.