NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Ready NAS Ultra 6 -- dead drive but no warnings. Says I still have redundancy. How?
I have an Ultra 6 with 6 disks. The 5th disk is dead according to the Health screen in FrontView. However when I go to Volume Settings it says: "Status: Redundant" How can I have redundancy ...
I had instances of drives being labled as "dead" when they were not on my Ultra 4. I had two "dead" drives, so my volume should have been corrupted, but it was not. Others reported similar problems, especially with specific drive types, even though they were on the compatibility list. Netgear has never given a satisfactory answer as to how it happens or how to fix it, save to "contact support" and pay for a solution.
I tried removng the drives (one at a time), deleting the partitions on a Windows machne, and re-installng them. After they were re-synced, all was well for a time, but it would happen again sooner or later. I finally realized it was happening when the drives spun up and turned off automatic spin-down, and the problem went away.
Thank you for the post. I'm at least partially comforted in knowing my system might be okay, however after disabling the spin-down feature, I still have the Dead label.
Since my system seems to be at full capacity, says "Redundant" and has issued no direct warnings, I tend to think it's working.
Did your Ultra 4 behave normally except for the "dead" labels? Or were there other points of concern?
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
