NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
ReadyNAS Replicate: "Connect error code: -51" since firmware update to 6.4.2
I have updated source (RN312) and target (RN104) from 6.4.1. to 6.4.2. Since that, every job failed. Example Log (eMail): [2016-02-16 08:00:05] [Info] Job updated from server
[2016-02-16 08:00:...
Apparently there have been some problems with our server recently. Are your Replicate backup jobs completing again now?
hm, I can see both devices on https://replicate.readynas.com / Views / Network.
Therefore I thought everything should be okay with the devices configurations.
I checked it: "ReadyNAS Remote" and "ReadyNAS Replicate" are active on both devices.
Also, "Internet" and "Services" are marked green on both.
Anyway, I have disabled and re-enabled the services on both devices as suggested.
Tomorrow I will check, wether jobs will run successful again.
Thanks and best regards, _frantic_
Hi _frantic_,
Just let us know if the backup runs again and if not, try to recreate and see if it works.
Kind regards,
BrianL
NETGEAR Community Team
Good: today, only 1 job was scheduled and did run as planned.
Bad: I have started the other jobs manually (https://replicate.readynas.com / Monitor / Run now this instance). They all failed with error code -51.
I have set up a test job and scheduled it ourly.
I will report back...
Hi _frantic_,
I have just run two backup jobs (at the same time) and it went just fine. Continue with your tests and let us know what happens.
Kind regards,
BrianL
NETGEAR Community TeamAlso, which services and apps are you running on your NAS?
What are your networking settings like? If you don't use IPv6, perhaps you could try disabling that for the network adapter in your NAS?
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
