NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Slow RAID0 to RAID0 on 314s with bonded gigabit
Hi, I've just set up two 314s in a small business. Each has 3 new WD Red 6TB drives in it, set up in RAID0. Both have two new <3m CAT6 cables going into the gigabit switch, and are bonded with adap...
Thanks for that. I disabled both of those but I don't know if it will take effect while it's in the middle of a backup. I'll experiment with multiple client downloads/uploads later when it's finished.
At any rate, the sending NAS currently has over 70% CPU idle, while the receiving NAS has over 50% CPU idle, so I can probably rule that out as a problem.
Both generally have less than 100MB of RAM free, but I imagine that's not likely to be an issue unless most of that was already used up before I started the transfer. Once again, I'll check that later after this initial backup finishes.
At any rate, the sending NAS currently has over 70% CPU idle, while the receiving NAS has over 50% CPU idle, so I can probably rule that out as a problem.
Both generally have less than 100MB of RAM free, but I imagine that's not likely to be an issue unless most of that was already used up before I started the transfer. Once again, I'll check that later after this initial backup finishes.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
