NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Stuck in Normal Boot, Boot menu working, Read only loads OK, Volumes show OK
I have a RN102 with 2x 3 YB drives in mirror It worked OK for a few years Now after reboot it just blincks the power LED in "loading" mode I can ping it but RAIDar does not detect it Using the Bo...
Logs sent. thank you so much
Cris
Your volume is fairly full (95%).
There is a known performance issue with the anti-virus service at the moment. Can you try disabling that under System > Settings > Services and then see if the NAS will boot normally?
If you still have the same problem try downloading the logs using RAIDar 6.1 before rebooting and send the fresh set of logs in.
Thank you, I have tried the suggested solution
However it appears that I cannot remove or update or change in any way the AntiVirus Plus app on the appliance.
May this be because the system is in read-only mode?
I have also unassigned a SCSI partition and removed the SCSI Share to make some space on the disk.
Still no luck, on reboot the power light blinks (long) and does not go solid, even if I wainted for more than a day...
Any other ideas?
PS For a short time at reboot the system is discovarable by RAIDar but that changes after a while,
Cris
I was referring to the Anti-Virus service under System > Settings > Services. Can you disable that service?
Thank you for the clarification.
Antivirus service is not green anymore and in the System, Overview page shows red/disabled for Anitvirus.
Unfortunatelly still no luck after reboot
On a side note - the SCSI LUN I have deleted has re-appeared...
Cris
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
