NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

Splinter051's avatar
Splinter051
Aspirant
Dec 04, 2021
Solved

CAX80 Ethernet ports not working

 Hello all,   Need some help! I am trying to connect to my modem/router wired. I'm using Cat5 that I know works and I understand that I should be using Cat6 for IPv6. I am just trying to use the 10...
  • FURRYe38's avatar
    FURRYe38
    Dec 05, 2021

    What Firmware version is currently loaded?

     

    Well you seem to be accessing the modems web page.

    Can you access the router side of the modem at 192.168.1.1? Might be 192.168.0.1

    If you can access the routers web page what is seen on the Basic tab under Home?

    Should show GOOD? 

     

    Be sure your wired PCs networking configuration is set for Auto Obtain IP addressing. 

    Be sure your using CAT6 patch cables. CAT5 does not support 1000Mpbs. 

    Try a different PC or laptop connected to the LAN ports. 
    Don't connect anything to the Multigig port for now. 

     

    Be sure your ISP has setup and activated the modem on there system. You'll have to contact them about this. 

     

Splinter051's avatar
Splinter051
Aspirant
Dec 05, 2021

I feel really dumb right about now lol! After reading what you posted, I decided to connect a small patch cable I had to the multi-gig port then check the other ports and they all looped back fine. I then connected the small patch cable to my laptop which connected just fine. My cable tester is not working so I went ahead and just cut off both RJ-45's from each end and re-wired. Works fine lol I'll get Cat-6 later.

 

Thanks for your response! Have a great day!