NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Ethernet has a self-assigned IP Address & will not be able to connect to the Internet
NETGEAR Nighthawk Multi-Gig Speed Cable Modem DOCSIS 3.1 for XFINITY by Comcast Two (2) Gigabit Ethernet port with auto-sensing technology. How do I set up this modenm so I can have one ethernet...
There is a lot of finger pointing on both (Comcast/Netgear) sides, isn't there?
It appears that users are expected to use communityforums so that they can share rumors since you don't get any official info on either side.
I would hardwire a pc/laptop into the extender and install it using the installation assistant. i would avoid wps. It gets coded different between manufaturers and can cause issues.
- Thanks for the reply.
Would i do that with an ethernet cable?
I did link it to a laptop and started the web process but still could not set up because it was not connected to the router.The setup process is what connects it to the router.
Start by factory resetting the extender. Push and hold reset for 7-15 seconds while powered on.
the after it reboots, connect the laptop to the extender with an ethernet cord. Disable the laptops wifi during setup so it doesn't default back to that connection.
then use the installation assistant. The support site has a video of the installation assistant being used. I thinks its the 2nd video on the support site.
