NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Unable to set Wan IP Address
Netgear ProSafe SRX5308 VPN Firewall
I cannot set an ip address on my wan2,3,4 interface.
I can set it on my wan1 interface as the default interface to the internet.
As I cannot set the ip addresses on wan interfaces 2,3,4, I cannot set up any routing between the wan interfaces
They are not being done automatically by the router itself - it does not recognise any ip addresses on these wan interfaces 2,3,4
These wan router interfaces are not being setup as a failover interfaces but as a wireless connection to the wan3 interface
which then routes to the wan1 interface (yet to achieve) and then out to the internet.
I allow incoming connections to the wan3 interface in this scenario.
1 Reply
Please post about this over in the VPN firewall forum:
https://community.netgear.com/t5/Hardware-VPN-Firewalls-and/bd-p/business-vpn-firewalls
Thank you,
txr20 wrote:Netgear ProSafe SRX5308 VPN Firewall
I cannot set an ip address on my wan2,3,4 interface.
I can set it on my wan1 interface as the default interface to the internet.
As I cannot set the ip addresses on wan interfaces 2,3,4, I cannot set up any routing between the wan interfaces
They are not being done automatically by the router itself - it does not recognise any ip addresses on these wan interfaces 2,3,4
These wan router interfaces are not being setup as a failover interfaces but as a wireless connection to the wan3 interface
which then routes to the wan1 interface (yet to achieve) and then out to the internet.
I allow incoming connections to the wan3 interface in this scenario.
