Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Vpn
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2015-03-12
09:17 PM
2015-03-12
09:17 PM
Hello, I need help I have my VPN set up for my R8000 but I'm not sure if it's running right. When I check my IP at http://ipaddress.com/ it shows my IP and location so I'm not sure if it's working...
Solved! Go to Solution.
Message 1 of 3
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2015-03-18
06:20 AM
2015-03-18
06:20 AM
Look on the bottom of the VPN Service page under Advanced Configurations.
Set the "Clients will use this VPN connection to access" radio button to the value "All sites on the Internet & Home Network". Once that's been saved you'll need to re-download the config files.
This will force the VPN to run "Full Tunnel" meaning ALL traffic runs through the VPN. http://ipaddress.com should then show your router's location/IP.
Set the "Clients will use this VPN connection to access" radio button to the value "All sites on the Internet & Home Network". Once that's been saved you'll need to re-download the config files.
This will force the VPN to run "Full Tunnel" meaning ALL traffic runs through the VPN. http://ipaddress.com should then show your router's location/IP.
Message 2 of 3
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2015-03-18
06:20 AM
2015-03-18
06:20 AM
Look on the bottom of the VPN Service page under Advanced Configurations.
Set the "Clients will use this VPN connection to access" radio button to the value "All sites on the Internet & Home Network". Once that's been saved you'll need to re-download the config files.
This will force the VPN to run "Full Tunnel" meaning ALL traffic runs through the VPN. http://ipaddress.com should then show your router's location/IP.
Set the "Clients will use this VPN connection to access" radio button to the value "All sites on the Internet & Home Network". Once that's been saved you'll need to re-download the config files.
This will force the VPN to run "Full Tunnel" meaning ALL traffic runs through the VPN. http://ipaddress.com should then show your router's location/IP.
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2015-08-14
08:54 PM
Announcements
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more