Bridge Mode on AC1600 Model R6330

[keithamason]

I'm trying to configure the AC1600 Model R6330 for bridge mode.  The manual indicates you go to ADVNACED > Advanced Setup > Rounter/AP/Bridge Mode.  However this is NO "Rounter/AP/Bridge Mode".

The manual doesn't have ANY screen shots, so I'm stuck.

[plemans · Accepted solution]

On the page you linked to, click on "use other operation mode" then "enable bridge mode"

[antinode]

> [...] R6330 [...]

> Model: R6300|Dual Band 11ac WiFi Router R6300

   Which is it?  Firmware version?

> [...] The manual indicates you go to ADVNACED > Advanced Setup >
> Rounter/AP/Bridge Mode. However this is NO "Rounter/AP/Bridge Mode".

   What _did_ you find there?

> The manual doesn't have ANY screen shots, [...]

   Neither does your complaint.

   Are you looking at ADVANCED > Setup or ADVANCED > Advanced Setup ?

[keithamason]

Version: V1.1.0.78_1.0.1

See attached image for the configuration screen

[plemans · Accepted solution]

On the page you linked to, click on "use other operation mode" then "enable bridge mode"

[keithamason]

Thanks.... I never would have figured that out.

As a note to anyone else trying to figure this out, the "setup  bridge mode wireless settings" was VERY hard to see. I missed it (see attached)

[antinode]

> [...] the "setup bridge mode wireless settings" was VERY hard to see.
> [...]

   True that!  Combine poor design with poor documentation, and you get
what?