- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Cannot enable Anywhere Access on Nighthawk App V2.7.0.27
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
When moving slider to enable Anywhere Accesson the Nighthawk app; "SOME ERROR OCCURRED WHILE ENABLING ANYWHERE ACCESS" POPS
All boxes are checked in the router's GUI..... rebooted the router few times to no avail, uninstalled/reinstalled Nighthawk App, that was a no go......Anyone else having this issue? Thanks
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just installed the latest firmware(V1.0.3.106_1.0.58) .......Anywhere Access still did not work. Since I usually do a factory reset upon completion of a firmware update, I did so. I can now enable Anywhere Access.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot enable Anywhere Access on Nighthawk App V2.7.0.27
Hi roger1955,
May you confirm what firmware version your router is on.
Thanks,
Christian
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot enable Anywhere Access on Nighthawk App V2.7.0.27
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot enable Anywhere Access on Nighthawk App V2.7.0.27
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot enable Anywhere Access on Nighthawk App V2.7.0.27
Hi roger1955,
Thanks for confirming. May you factory reset your router and run through the setup assistant again and also setup anywhere access.
Thanks,
Christian
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot enable Anywhere Access on Nighthawk App V2.7.0.27
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot enable Anywhere Access on Nighthawk App V2.7.0.27
Hi roger1955,
Sounds good. Please feel free to provide me with further updates.
Regards,
Christian
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just installed the latest firmware(V1.0.3.106_1.0.58) .......Anywhere Access still did not work. Since I usually do a factory reset upon completion of a firmware update, I did so. I can now enable Anywhere Access.
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more