Hello all, As I discussed in March, our new home is fully wired with CAT6 cables wherever a TV or Computer is going to be. Probably 10 locations.https://community.netgear.com/t5/Orbi/Orbi-RBK53-system-Should-I-wire-new-home-for-ethernet/m-p/1871049#M84104In my previous thread, I was still discussing wireless connections. So, I was advised to keep the router in the main room and wire back to the basement and use the switch to provide direct connections to the satellites. I am now wondering if I need to do that even. If I keep the modem & the router in the communication closet in the basement, then buy a 10 or 15 port unmanaged, non green switch, can I not just connect all the CAT6 cables going to each room to the back of the switch and use RJ45 cables in each room to get a wired connection for each device instead of wireless?

ShankarHokie wrote:The house will be 2800 sq ft. 3 levels. Nothing to be connected in the basement. 2 offices and a media center in the first floor. Network connected garage door opener. 4 media ceners in the 2nd floor. All of these spots have network drops with cat 6 wiring.Now that I think about it, I might have to connect at least one RBS for our cell phones to connect to the home network vis wifi.I was hoping that I can connect all my TVs and media devices to the wired network without having the satellite next to them.My home has a similar setup to what you are askiing. My Orbi system is RBR50 router, 2 RBS50 satellites, 1 RBS40V satellite.The Orbi system is a plus because I love having full WIFI throughout my home for phones, tablets, cameras, and Amazon Echos and smart devices.With that said, I go from the ISP modem to the Orbi router to a large switch with cables to various rooms for hard wired devices. In 2 strategic office areas I have a satellite connect to the cable from the switch and then plugged a switch into each of the satellites for more hard wired connections in those areas. The end result is I have full fast wired and WIFI coverage throughout my home and a separate building.

House wired with CAT6. Can I use a network switch instead of satellites and wifi

8 Replies

FURRYe38
Guru - Experienced User
Sep 09, 2020
Copy Link
Yes you can. Please follow this guide for wire connecting the RBS to the RBR using a switch:
https://kb.netgear.com/000051205/What-is-Ethernet-backhaul-and-how-do-I-set-it-up-on-my-Orbi-WiFi-System
- ShankarHokie
  Apprentice
  Sep 09, 2020
  Copy Link
  Thanks FURRYe38 . I was wondering if I even need to use the RBS50.
  - FURRYe38
    Guru - Experienced User
    Sep 09, 2020
    Copy Link
    The RBS would be considered as wired APs if you used them if your not looking for wireless coverage on the area then you may not need them at all.
    
    RBS are for additional wifi coverage through out the home and in remote locations were wifi signal may low or not existent.
    
    What is the size of your home? Sq Ft? IF you have a small home, then you may only need the RBR. I have a 5000sq ft home and have 1 RBR and 1 RBS and this works well for my size of home.
    
    30 feet or more is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router

Forum Discussion

House wired with CAT6. Can I use a network switch instead of satellites and wifi