Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GS324TP switch AGM731F SFP modules not coming online
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2023-01-31
05:07 PM
2023-01-31
05:07 PM
I have a GS324TP switch. I'm new to netgear. Looking at the datasheet below I can see the AGM731F SFP module is supported. Once connected looking at the web interface in the cable test section I can see both SFP modules showing up as "invalid cable type". I can see in the trap logs that SFPs were inserted, I don't see anything else to get much insight.
How would I move forward in troubleshooting this?
Software version 1.0.0.38
Solved! Go to Solution.
Message 1 of 3
Labels:
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2023-02-02
04:18 PM
2023-02-02
04:18 PM
It turns out the issue was an incompatibility with the SFP in my router.
Message 3 of 3
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2023-02-01
12:47 PM
2023-02-01
12:47 PM
Re: GS324TP switch AGM731F SFP modules not coming online
Not convinced there are any cable test capabilities for fiber modules.
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2023-02-02
04:18 PM
2023-02-02
04:18 PM
It turns out the issue was an incompatibility with the SFP in my router.
Message 3 of 3