Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: GS728TPPv2 M4100-24PoE+ Port PVID question with two vlans
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-09-14
10:43 AM
2021-09-14
10:43 AM
GS728TPPv2 M4100-24PoE+ Port PVID question with two vlans
I have set up two vlans with different subnets with dhcp and dns enabled on my UTM. These are both set on one port on the UTM.
When I connect this port to my switch I have to configure the switch port to receive this connection.
I have set up the port on the switch to connect as U-ntagged on the port and it is a member of both VLans but... I understand I can only set one PVID per port which defaults to 1 but this is usually the case for T-runked ports.
Am I right to use U on the connection to UTM or should it be T?
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-09-14
11:12 AM
2021-09-14
11:12 AM
Re: GS728TPPv2 M4100-24PoE+ Port PVID question with two vlans
You can configure the trunk port for the UTM<->Switch link on both sides as tagged for all VLANs, or you can keep _one_ VLAN untagged with the same PVID obviously.
Message 2 of 2