This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
I have an GS748TP with version V1.0.0.22 software works good, that I want to upgrade to latest software version. The instructions for the upgrade indicate that I need to first upgrade to boot code 1.0.0.5, currently installed is 1.0.0.4. Where can I get boot code 1.0.0.5. I do not see it on the netgear website.
The instructions also say I must interim image (GS700TP_V1.0.0.inter.ros) first.
Which one do I do first the boot code or the image file???
Where do I download the image file? I wish the Netgear website was more helpful and clear on home to upgrade.
Where can I get boot code 1.0.0.5. I do not see it on the netgear website.
Kindly download firmware v5.0.0.14 then unzip it and you will get the boot code v1.0.0.5 as well as the GS700TP_V1.0.0.inter.ros.
The instructions also say I must interim image (GS700TP_V1.0.0.inter.ros) first.
Which one do I do first the boot code or the image file???
I have an GS748TP with version V1.0.0.22 software works good, that I want to upgrade to latest software version. The instructions for the upgrade indicate that I need to first upgrade to boot code 1.0.0.5, currently installed is 1.0.0.4.
Since you mentioned that your GS748TP is on v1.0.0.22, then you need to upgrade the switch to the interim image first (GS700TP_V1.0.0.inter.ros). Then, perform the upgrade again from the interim image to V3.0.6.1.
The procedure for upgrading the device to the interim image is the same as the regular firmware upgrade.
Where can I get boot code 1.0.0.5. I do not see it on the netgear website.
Kindly download firmware v5.0.0.14 then unzip it and you will get the boot code v1.0.0.5 as well as the GS700TP_V1.0.0.inter.ros.
The instructions also say I must interim image (GS700TP_V1.0.0.inter.ros) first.
Which one do I do first the boot code or the image file???
I have an GS748TP with version V1.0.0.22 software works good, that I want to upgrade to latest software version. The instructions for the upgrade indicate that I need to first upgrade to boot code 1.0.0.5, currently installed is 1.0.0.4.
Since you mentioned that your GS748TP is on v1.0.0.22, then you need to upgrade the switch to the interim image first (GS700TP_V1.0.0.inter.ros). Then, perform the upgrade again from the interim image to V3.0.6.1.
The procedure for upgrading the device to the interim image is the same as the regular firmware upgrade.
