- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Prosafe Plus Utility End of Life
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I just have seen that the ProSafe Plus Utility is end of life. What is the actual software then?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the community! 🙂
The ProSAFE Plus Utility was a tool use to detect, setup and upgrade the firmware of early models of the ProSAFE Plus Switch family (such as the GS108Ev1) because most of these switch models does not support a web-GUI.
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the community! 🙂
The ProSAFE Plus Utility was a tool use to detect, setup and upgrade the firmware of early models of the ProSAFE Plus Switch family (such as the GS108Ev1) because most of these switch models does not support a web-GUI.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Prosafe Plus Utility End of Life
Dear DaneA
many thanks! Yes, for my switches I can use the GUI instead, so I won't need the software anymore in the future.