NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
OS 6.10.5 - Cannot install application Docker CE CLI
Hi, my system updgraded from 6.10.4 to 6.10.5. Suddenly docker will not start and I'm not able to reinstall it by installing docker CLI. How do we get docker up and running again? Downgr...
I'm bit by this as well. I tried to remove and reinstall via command line and get the following:
The following packages have unmet dependencies:
docker-cli-rnapp : Depends: linux-image-extra but it is not going to be installed
Depends: docker-ce (>= 17.09.0~ce-0~debian) but it is not installable
Hi there
I've got the same problem here, I've tried everything but nothing works to reinstall Docker on the NAS.
I hope they'll fix it soon or give us a workaround. It's a shame, Docker is always used and known to be compatible with nearly everything.
Cheers,
Louis
Update on my efforts. Adding Docker to 6.10.5 via the pre-build DEB or adding the Docker source both fail.
I was able to roll back to 6.10.4 and install docker-ce again. It failed via the web interface so I had to use apt and guide the system through the installation issues. Plymouth keeps failing but appears to not be needed, portainer is failing to install afterwards so I manually installed the latest via docker command.
Another thing to watch out for, removing the old docker-ce removed my storage so I'm starting over on all my docker containers.
Did you have to restore your data from backup after the 6.10.4 downgrade or was it a simple flash of the 6.10.4 firmware?
I flashed the firmware manaully and it took, not sure it is the safest thing to do. I have some UPC weirdness on that box sending low battery alarms which I'm trying to isolate now so there may be some negative effects.
What Firmware is currently loaded?
Modem Combo Units:
This would be a double NAT condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop
WEG3 wrote:
I have TWC/Spectrum telephone landline and internet using TWC’s Sagecom router and Arris modem. I connected my new Orbi RBR 40 (router and 2 satellites) to the single Arris ethernet port, but had to disconnect the Sagecom router from the Arris modem in order to do so. I now have internet, but no TWC telephone service. How can I recover my telephone service and keep Orbi’s working? Am I configured correctly?
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
