This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
Greetings everyone. I just purchased this 2 drive unit and I'm having issues getting to the setup screen. I can see the unit on my network but the setup screen fails with
The connection for this site is not secure
10.0.0.109uses an unsupported protocol.
ERR_SSL_VERSION_OR_CIPHER_MISMATCH
I've tried Edge, Chrome and Firefox, none give me the option to bypass the secure connection. Ive read thru most of the discussions here and none seem to answer the issue. Any suggestions?
Greetings everyone. I just purchased this 2 drive unit and I'm having issues getting to the setup screen. I can see the unit on my network but the setup screen fails with
The connection for this site is not secure
10.0.0.109uses an unsupported protocol.
ERR_SSL_VERSION_OR_CIPHER_MISMATCH
I've tried Edge, Chrome and Firefox, none give me the option to bypass the secure connection. Ive read thru most of the discussions here and none seem to answer the issue. Any suggestions?
Edge in IE mode should work. There is a setting in FireFox to allow TLS 1.0 connections, the posts at the end of the above link will point you to that.
After you are in, you can enable ssh, and then edit virtual.conf as described in the beginning of the above link.
This isn't the only issue you will run into - the NAS will also require you to enable SMB 1/CIFS on the PCs.
Netgear stopped selling it back in 2011, and the final firmware release was in 2017.
Other labels are confusing, and frequently lead to v1 owners mistakenly thinking they have a v2.
And to eBay sellers selling V1 units as V2's. Most "V2" units I see for sale are V1's. Given the part number, which I suspect ends with -100), it shipped with one 500GB drive. AFAIK, no "real" V2 units did so.
