NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Says Your access point has no Internet access but still works
It says: Your access point has no Internet access. Check to make sure that your router has an Internet connection. But, it still works fine as a wired AP off my Asus Router. Why is it saying that...
+1. I was able to do an update after enabiling IPV6 as suggested on my primary. Its crazy that even a manual download and upload of the new firmware to the extender did not work without IPV6 being enabled.
Oh man. I thought it worked but it did not. It "made it further" by actually showing me the updated firmware release notes and asking me to confirm. But after procedding it failed again with some message about accessing a netgear site. Again, I could not update the firmware manually.
I did a factory reset, set it up as an extender and then it successfully did the firmware update automatically after prompting me to update. So IPV6 may be a factor but a factory reset was required (at least for me) to go to 1.0.0.58.