NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Says Your access point has no Internet access but still works
It says: Your access point has no Internet access. Check to make sure that your router has an Internet connection.
But, it still works fine as a wired AP off my Asus Router. Why is it saying that?
Thanks.
5 Replies
i noticed the same problem today, cant explain it as everythings working but i had a few dropouts on some connected wifi cameras during the day so its not helping with the troubleshooting.
AC1900 WiFi Access Point
- Hardware Version EX7000
- Firmware Version V1.0.0.50_1.0.102
I have the same problem.
There is another thread on this community with several others having the same problem. So far no solutions as yet.
After lots of reading, I finally determined that this is from the AC1900 expecting IPv6. My upstream Netgear Router (R6400 w/ Firmware Version V1.0.1.26_1.0.19) was limiting network to IPv4.
The EX7000 | AC1900 No internet connection error went away after enabling IPv6 connection on the main router in Advanced - Advanced Setup - IPv6 and changing Internet Connection Type from "Disabled" to "DHCP" and Auto Config.
Hope this helps.
-jb