NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
cli
1 Topic
WNDAP350 CLI Factory Default syntax
Hi, Firmware has left me with a cut down 'cloud connect' type GUI. I need to reset via CLI as suggested by the firmware upgrade notes as the button reset did not restablish the full GUI. I have tried the suggested restore-configuration /etc/default-config And an error appears asking for restore host username password All CLI command lines are prefeixed by netgear70B528 which I assume is 'host' But this fails with bad address. So I subsituted the default IP address for host. This time it said connection refused (or similar). Is this because I need to enable something via the CLI first? If so what? I tried the CLI restore-configuration command and this simply did the same as the button reset. What do I do? AndySolved4.8KViews0likes3Comments