NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
hard drive
3 Topics
Replacing Hard Drives RN102 - Raid 0
If I'm replacing the hard drives in a Raid 0 configuration (upgrading from 2x2 to 2x8), does it require that I factory reset the NAS? I can't remember if I can just replace the drive and then go to the admin page and format them. Thanks,Solved1.4KViews0likes1Comment
Can't Replace HDD in Bay 1
My RN202 had two Seagate Barracuda 1TB drives in it and one of the drives started to fail. The failing drive was in Bay 2. I wanted to replace both drives with 1 TB Seagate NAS drives (ST1000NV000) which I have. I removed the failing drive from Bay 2 and installed the freshly formatted NV drive. The OS 6.5 admin page showed the new drive in red. I formatted the drive using the format button on the admin page. The drive formatted and the RN202 started the resync process. Several hours later when the RN202 notified me that the status was changed from degraded to Heathly, I pulled the drive out of bay 1 and installed the second NV drive but I am not getting the same behavior. The admin page does not show the drive in Bay 1 needing to be formatted and the shares do not register. If I try to reboot, I just get a blinking power button and the RN202 will not boot. If I put the original Barracuda drive back into Bay 1, the system boots normally and then does another resync. until the status again changes to Healthy. I even tried putting the newly synced NV drive from Bay 2 into Bay 1 and putting the unformatted NV drive into Bay 2 but the unit still won't boot or recognize the drive in Bay 1. The upgrade of the drive in Bay 2 was very easy and went smoothly. Why doesn't the upgrade of the Bay 1 drive do the same? I would think that at the least, putting the newly synced NV drive from Bay 2 to Bay 1 would have worked. Any thoughts or suggested would be appreciated. Regards, DavidSolved4.1KViews0likes8Comments
ReadyNas 104 maximum expansion
Hi evryone, today is a second day with my ReadyNas 104 and I'm very satisfied of this product ! I have one question on the maximum volume capacity to 16TB with the new firmware. The best solution with x-raid is 2x 5TB and 2x 6TB hard drive? so as have 15TB? Now my ReadyNas has 2x 3TB WD RED and I want considering the best volume upgrade by future. Thanks, GiusepeSolved3.9KViews0likes5Comments