Backhaul Broke?

Question

Ever since updating from 2.3.1.44 to 2.3.1.60, my ethernet backhaul no longer connects.&nbsp; It only shows 5G backhaul.&nbsp; This happen to anyone else?

FURRYe38 · Answer

If it shows 5G then it's working. Unless your RBS is wired?&nbsp;
Has a factory reset and setup from scratch been performed on the system?&nbsp;
&nbsp;

johnny5126 · Answer

I have one RBR50 connected in the WAN port going to a switch, and a cable going from the switch to a port on the RBS50. Looking at the connected devices in the past showed wired, but now it shows 5g.

FURRYe38 · Answer

What is the Mfr and model# of the ethernet switch in the configuration.
This is ethernet back haul.
&nbsp;
Is Daisy Chain enabled? It should be disabled when ethernet connected between RBR and RBS.&nbsp;Under Advanced Tab/Advanced Settings/Wireless Settings

johnny5126 · Answer

The switch is a netgear jpe16. I have another RBS40 connected wireless ly so don't I need daisy chain enabled? My RBR50 is in AP mode.

SW_ · Answer

johnny5126&nbsp;wrote:I have one RBR50 connected in the WAN port going to a switch, and a cable going from the switch to a port on the RBS50. Looking at the connected devices in the past showed wired, but now it shows 5g.
That seems to be the culprit.&nbsp; The cable should be connected from RBR50 LAN port to the switch.&nbsp; Then RBS50 WAN port should be connected to the (same) switch.
&nbsp;
Take a look at this link.

Forum Discussion

Backhaul Broke?

7 Replies