RBR50 + 2x RBS50, wireless backhaul. After upgraded to 2.3.5.30, the 2 satellites keep disconencted from RBR50, sometimes satellites reconnected back to RBR50 after few mins, sometimes they didn't, I had to restart satellites. did factory reset on satellites, no help at all.

Try a factory reset on the RBR. If you only reset the RBS and not the RBR after the FW update, this could help. I setup my RBK50 system again in AP mode, yesterday. RBS is wired though. No issues here.

horrible 2.3.5.30 | NETGEAR Communities

7 Replies

sh2sg
Apprentice
Jul 31, 2019
AP mode.

They used to be very stable in the past one year with 2.2.x.x firmware
- FURRYe38
  Guru - Experienced User
  Jul 31, 2019
  Try a factory reset on the RBR. If you only reset the RBS and not the RBR after the FW update, this could help.
  
  I setup my RBK50 system again in AP mode, yesterday. RBS is wired though. No issues here.
  - sh2sg
    Apprentice
    Aug 04, 2019
    I did factory reset on RBR50 3 days ago and it ... did help. I didn't encounter any disconenction so far. Thanks for the tip.
    
    I hope I don't need to do factory reset on all units regularly...
ekhalil
Master
Jul 31, 2019
What types of devices are attached to Orbi?
I experienced that latest Orbi SW releases are “sensitive” to some attached devices.
No issues with phones, computers and tablets as I could see. Please disconnect all other devices, forget networks on those devices and attach again.
Retired_Member
Jul 31, 2019
sh2sg wrote:
RBR50 + 2x RBS50, wireless backhaul.

After upgraded to 2.3.5.30, the 2 satellites keep disconencted from RBR50, sometimes satellites reconnected back to RBR50 after few mins, sometimes they didn't, I had to restart satellites.

did factory reset on satellites, no help at all.

Why did you upgrade your firmware?

Forum Discussion

horrible 2.3.5.30