NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi not showing devices in AP mode
Orbi RBR50 firmware V2.5.1.8 not showing any devices in AP mode.
I can see all the devices on the internet provider's router. It should have 2 satellites, many WiFI devices and network/ethernet connected devices. I've logged into the Orbi local web app admin and it shows 0 satellites and 0 devices. The mobile app shows only 2 satellites but 0 attached devices. Yes, i've rebooted the Orbi after setting up in AP mode.
Thanks.
11 Replies
Please try a factory reset and setup from scratch with the RBR and RBS.
How is the RBR and RBS connected?
Are the RBS ethernet connected or wireless?
biocoder wrote:Orbi RBR50 firmware V2.5.1.8 not showing any devices in AP mode.
I can see all the devices on the internet provider's router. It should have 2 satellites, many WiFI devices and network/ethernet connected devices. I've logged into the Orbi local web app admin and it shows 0 satellites and 0 devices. The mobile app shows only 2 satellites but 0 attached devices. Yes, i've rebooted the Orbi after setting up in AP mode.
Thanks.
- I forgot to mention that I did perform a factory reset because of this issue in an attempt to resolve it.
Is Daisy Chain enabled? Disable it if it is.
You can try downgrading FW to v30 or give Voxels FW a try:
biocoder wrote:
I forgot to mention that I did perform a factory reset because of this issue in an attempt to resolve it.
