Can't rename Port Channel in CLI - MX4300-96X

Hello,

I'm trying to rename a port channel through CLI. I haven't got any error but when I check with the show command it appears that my modification was not apply.

I've tried with multiple character (caps, no caps, dash, no dash, ...) and I got the same problem.

I've also tried to finish the configuration of my PC/LAG (port affectation, ...), my port channel is still not rename but all my other operation was apply.

My firmware version is : 10.0.17.12

There is my CLI output :

(M4300-96X) (Config)#port-channel name lag 1 LAG-NAS-ARCH-01

(M4300-96X) (Config)#show port-channel all

Log. Channel Admin Load Mbr Device/ Port Port
Intf Name Min Link Mode Type Balance Ports Timeout Speed Active
------- --------------- ---- ------ ------ ---- -------- ------- ------------- --------- -------
lag 1 ch1 1 Down Dis. Dyn. 2 1/1/1 actor/long 10G Full False
partner/long
1/1/2 actor/long 10G Full False
partner/long
lag 2 ch2 1 Down Dis. Dyn. 2
lag 3 ch3 1 Down Dis. Dyn. 2

Thanks in advance for your help.