NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
M4100-24G-POE+ switch has no POE
I have M4100-24G-POE+ switch that is working fine except for POE. I found this post with a similar issue and tried downgrading the firmware to 10.0.2.26 but Poe Version on the System Management p...
Thanks for that information. The switch was purchased used so it would not be covered by the warranty.
I finally had an opportunity to open the case a take a look inside. I found that the original fans had been replaced and the POE power board had apparently been unplugged for easier access to the fan connectors. The plug for the POE section had not been plugged in all the way. I pulled the plug and pushed it back in properly. When I started the switch back up all of the POE configuration information was back and the ports were supplying power as expected. Everything has been working fine since, so that seems to have been the cause.
Let us try to perform a factory reset on your M4100-24G-POE+ then observe if the same problem will occur.
Regards,
DaneA
NETGEAR Community Team
Thank you for your response. It would be best if you open a support ticket with the NETGEAR Support Team here at anytime for a hardware check. If ever the M4100-24G-POE+ has been declared faulty, be ready to submit a soft copy of the Proof of Purchase of it for warranty verification. If the hardware warranty is still valid, an online replacement will be processed.
Regards,
DaneA
NETGEAR Community Team
Thanks for that information. The switch was purchased used so it would not be covered by the warranty.
I finally had an opportunity to open the case a take a look inside. I found that the original fans had been replaced and the POE power board had apparently been unplugged for easier access to the fan connectors. The plug for the POE section had not been plugged in all the way. I pulled the plug and pushed it back in properly. When I started the switch back up all of the POE configuration information was back and the ports were supplying power as expected. Everything has been working fine since, so that seems to have been the cause.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
