NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
M5300-52G Blinking yellow power. No access to CLI How to reset
m5300-52G V1K1 10.0.0.31 firmware.
I had reset this unit as it was part of a stacked environment and now will be seperate. The reboot worked and then I was adding config back in and needed to erate to start again. After the erase commant the unit will not re-boot it is stuck with a blinking yellow power lignt and no port activity is shown. I have tried to access via cli and there is no echo. Is there any way to restore this unit or is it dead?
1 Reply
Welcome to the community! :)
Let me share the article below and use it as your guide to perform XMODEM:
What do I do when my FSM managed switch does not boot up?
Regards,
DaneA
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
