NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
GS348T switch repeatedly stuck without any reason
Hello This switch has been in production since march 2021. It's setup is quite simple : it only uses VLAN segmentation (x13). So during 3 months it has been working very well. But yesterday, it was ...
Hello @ JohnC_V and thank you for your interest,
There're 34 devices connected to this switch, and only one port is connected to another switch. As I don't see how a loop could happen with this settingn I didn't activate the L2 Loop Protection mode (it's a smart switch, so there's none "visible" STP or RSTP setting). But the anti-storm mechanism is activated.
I've received an assistance from Netgear support but they didn't detect anything anormal in the switch configuration. And there's none log relative to this incident. They told me if another stuck episode would happen again, they will change the switch.
FMJ999 wrote:
There're 34 devices connected to this switch, and only one port is connected to another switch. As I don't see how a loop could happen with this settingn I didn't activate the L2 Loop Protection mode (it's a smart switch, so there's none "visible" STP or RSTP setting). But the anti-storm mechanism is activated.
Assuming the GS348T model designation is correct, the STP and RSTP config are under Switching > STP > Basic > STP Configuration resp. t Switching > STP > Advanced
I would avoid and at least temporarily disabling any kind of anti-storm protection.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
