GS728TPV2 MAC ACL problems Firmware Version V6.0.6.2

Good morning every one ,

I have the smart managed Switch GS728TPV2, for Security , i want to enable only the company device to be able to access the network .

I tried to do this with MAC ACL based on source MAC 

the configuration looks like where XX is the Mac of the laptops ,pc..etc

sequence 1 permit XX:XX:XX:XX:X:XX/00:00:00:00:00:00 any vlan any cos any ethtype any asq any mirror any redirect any matchEvery 0 logging 0 ethKey any
sequence 2 permit XX:XX:XX:XX:X:XX/00:00:00:00:00:00 any vlan any cos any ethtype any asq any mirror any redirect any matchEvery 0 logging 0 ethKey any
sequence 3 permit XX:XX:XX:XX:X:XX/00:00:00:00:00:00 any vlan any cos any ethtype any asq any mirror any redirect any matchEvery 0 logging 0 ethKey any

and then i bind to All the ports like this (example not to make it toong )

interface g1
acl bind seq 1 "LAN"

upto 4 seuences it work ,

if i connect usb to ethernet dongle not in the mac in the list it doesn't get access to the netowrk and i tried on all port .

Problem However , if added more sequence than this 4 (even just one more sequence so in total 5 rules) ( my final list should be 30 sequence)  and i test again , it works on the first 3 port but all other ports it gets the connection and can ping the resources inside which souldn't be the case 

am sure i binded on all ports .

so can you tell me what am doing wrong ? appreciate the help as i have been in circle for days aorund this problem .