Forum Discussion

Aspirant

Jun 21, 2018

Solved

how to enable Jumbo Frames on XS748T? Can't find the setting.

I have searched and found a article on the site showing how to enable Jumbo Frames on Pro Safe switches, but the interface in the XS748T looks different than their example and I can't find where to enable Jumbo Frames on the XS748T.

Anyone know how?

Thanks!

Troubleshooting

Carl_z
Jun 28, 2018
Hi gparkerCOB

Sorry for late to back, I missed your reply.

For XS748T Jumbo Frames is enabled by default. You can just use Jumbo Frames without any configurations.

BestRegards

Carl

4 Replies

Carl_z
NETGEAR Expert
Jun 22, 2018
Hi gparkerCOB,

Welcome to the community!

You can go to "Switching/Ports/Port Configuration/" There is a value named "Maximum
Frame Size". Just set this value to max to enable Jumbo Frames.

Best Regards

Carl

Netgear Employee
- gparkerCOB
  Aspirant
  Jun 22, 2018
  Thanks Carl! I wish ours looked that way. The image you attached is much like the knowlagebase had seen while sreaching for the answer. But our switch does not have that value to change. Is it because all the ports on the switch are 10GbE? See the image below.
- gparkerCOB
  Aspirant
  Jun 27, 2018
  Carl,
  
  Any ideas why our switch doesn't have that setting you talked about?
  
  Thanks
  - Carl_z
    NETGEAR Expert
    Jun 28, 2018
    Hi gparkerCOB
    
    Sorry for late to back, I missed your reply.
    
    For XS748T Jumbo Frames is enabled by default. You can just use Jumbo Frames without any configurations.
    
    BestRegards
    
    Carl