FVS336G and Bluecoat Filter/ IPSec

I don't see the attachment arrow in any browser to allow me to upload teh screenshots. But here is the summary:

VPN Policy:

General:

Policy name: Bluecoat
Policy Type: Auto Policy
Select Local Gateway: WAN 1
Remote Endpoint: IP address from Bluecoat
NetBIOS, rollover, Keepalive not enabled.

Traffic Selection:
Local IP: Subnet
Start IP Address: 192.168.0.0
Subnet Mask: 255.255.255.0
Remote IP: any

Manual Policy Parameters: Greyed out

Auto Policy Parameters:
SA Lifetime: 3600 Seconds
Encryption Algorithm: 3DES
Integrity Algorithm: SHA-1
PFS Key Group:
DH Group 2 (1024 bit)
Select IKE Policy: Bluecoat

IKE Policy:

Mode Config Record? no
Policy Name: Bluecoat
Direction/type: Both
Exchange Mode: main
Local Gateway: WAN1
Identifier Type: Local Wan IP
Identifier: IP address from Comcast
Remote Identifier type: Remote WAN IP
Identifier: IP from Bluecoat
IKE SA Parameters:
Encryption Algorithm: 3DES
Authentification Algorithm: SHA-1
Authentification Method: Pre-shared Key
Pre-Shared Key
DH Group: Group 2 (1024 bit)
SA Lifetime: 28800
Enable Dead Peer Detection: No
XAuth Configuration: None