Port forwarding on FVS318G

pretty obvious

you don't have public IP on WAN of FVS

ok, how can solve it?

see router setup on my sig below

ok i read the guide, but i can' t configure my modem/router in bridged mode (it's a isp modem/router "locked"), i have only double nat option.
In this case how can open port on my firewall?

Yes..............

If you can not change anything and there isn't much you can do

You should consult with your ISP

Hi, my ISP say that is not possible to configure modem/router in bridge mode, this setting does not exist in the configuration page.
I forgot to tell you that my ISP modem/router is set in "static NAT" mode so the firewall is off and all traffic that arrives on isp modem/router (192.168.1.1) is redirect to a single address (192.168.1.2)
At this point there is' a way to successfully open the port on FVS318G?

Many thanks for patience...

I add an other info, i can reach from internet the configuration page of FVS318G with http:\\ddns:8080 but I can not reach the server behind the firewall.

many thanks

if you reach via public IP then I would check any ports you are using is not block by ISP

Hi, the isp does not block any ports because if i remove the FVS i can reach the server.

Thanks