Forum Discussion

Aspirant

Aug 31, 2018

SRX 5308 Site-to-Site VPN not fully working

Hi all, New to the SRX5308 and Site-to-Site VPN. I have used the wizard and believe that I have a successful tunnel between two SRX5308. I have done nothing other than run the wizard. I can...

Troubleshooting

DaneA

NETGEAR Employee Retired

Sep 10, 2018

JamesN33,

You may want to open a chat or online support ticket with the NETGEAR Support Team and attach the logs so that it will be forwarded to the engineering team for it to be analyzed.

Kindly try to use another WAN port of the SRX5308 on both Site A and Site B. Then, set up a VPN tunnel using the VPN Wizard as well. Check if the same problem will occur. You may want to perform a factory reset on both SRX5308 then reconfigure the setting from scratch and observe.

Regards,

DaneA

NETGEAR Community Team

DaneA

NETGEAR Employee Retired

Sep 12, 2018

JamesN33,

Yes, the VPN traffic should not be affected by the firewall rules. Firewall rules are meant for LAN/WAN traffic.

Regards,

DaneA

NETGEAR Community Team