Wireless devices not connecting to WAX214 when VLAN isolation enabled

Thank you for the reply, however, I do not see an issue with my config that I posted. I am not an experienced network engineer so I may be wrong, but on a cisco switch, would you not configure this as a VLAN trunk port? In addition, If I were to configure this as just an access port, I do not believe there is a way to do this other than trunking. On an aruba device, I know you would configure this to be an untagged interface with the required vlans, however, I do not see a path to configure this other than I already have. If the device is doing what it is supposed to, shouldn't it be sending the traffic over the interface, and to the pfsense firewall? In addition, how would this cause my devices to not even connect? My devices aren't just unable to access the internet, but are unable to create a connection and complete a handshake with the WAX214.