MR60 / MS60 Firmware Version 1.1.6.124 Access Control No Longer working

Question

My router updated to V1.1.6.124 yesterday and now access control from the iphone app no longer works. There is a new slider when you select the device, but the slider is grayed out and you cannot change it.&nbsp; This setting can still be updated using the web interface.&nbsp; Anyone else have this problem?

FURRYe38 · Answer

Got a screen capture of this?&nbsp;
Is Armor enabled?&nbsp;
Has a factory reset and setup from scratch been performed since update?&nbsp;
Be sure to disable WiFi Private Address and&nbsp; Limit IP Address Tracking on Apple devices.&nbsp;

niallg · Answer

No. Reboot is as far as I went.See example screenshot attached. Before the upgrade there were pause and play buttons to block and unblock devices.

FURRYe38 · Answer

Is this behavior seen for all devices?&nbsp;
Possible new app update did something.&nbsp;

niallg · Answer

Yes it’s the same for all devices. That was only an example. I did a factory reset and setup yesterday It is the same. Either the new app version or the latest firmware has broken this functionality.

FURRYe38 · Answer

Be sure to disable WiFi Private Address and Limit IP Address Tracking on the any Apple phones or pads.&nbsp;

Forum Discussion

MR60 / MS60 Firmware Version 1.1.6.124 Access Control No Longer working

5 Replies